Enterasys Networks D-Series - Manual (Page 301)

Creating Diffserv Classes and Matching Conditions
Enterasys D-Series CLI Reference 10-3
Creating Diffserv Classes and Matching Conditions
Purpose
To review, create, and configure Diffserv classes and matching conditions.
Commands
show diffserv info
Use this command to display general Diffserv status information.
Syntax
show diffserv info
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display general Diffserv status information:
D2(rw)->show diffserv info
DiffServ Admin Mode............................ Enable
Class Table Size Current/Max................... 0 / 25
Class Rule Table Size Current/Max.............. 0 / 150
Policy Table Size Current/Max.................. 0 / 12
Policy Instance Table Size Current/Max......... 0 / 120
Policy Attribute Table Size Current/Max........ 0 / 120
Service Table Size Current/Max................. 0 / 48
For information about... Refer to page...
show diffserv info 10-3
show diffserv class 10-4
set diffserv class create 10-4
set diffserv class delete 10-5
set diffserv class match 10-5
set diffserv class rename 10-8