Enterasys Networks D-Series - Manual (Page 508)

set policy maptable response
17-46 Security Configuration
multiauth port command (page 17‐37) to set the number of RFC 3580 users (numusers) allowed
per Gigabit port. Up to two users can be configured per Gigabit port.
Syntax
show policy maptable response
Parameters
None.
Defaults
None.
Mode
Switch command, read‐only.
Example
This example shows how to display the current policy maptable response setting:
D2(rw)->show policy maptable response
policy
set policy maptable response
Sets the maptable response from the default of policy to tunnel to allow up to VLAN authorized
users to be configured per Gigabit port.
Syntax
set policy maptable response {policy | tunnel}
Parameters
Defaults
Set to policy.
Mode
Switch command, read‐write.
Usage
This command puts the switch in either “policy mode” (the default) or “tunnel mode,” which is
RFC3580 VLAN mapping.
policy Sets the maptable response to policy. This is the default setting, which
allows authentication of up to two multiauth users per port.
tunnel Sets the maptable response to tunnel, which allows authentication of up
to two multiauth users per port. This setting is required to configure
VLAN authorization for multiple users per Gigabit port.