Enterasys Networks D-Series - Manual (Page 327)

set policy rule
Enterasys D-Series CLI Reference 11-11
Defaults
None.
Mode
Switch command, read‐write.
Usage
Table 11‐30 provides the set policy rule data values that can be entered for a particular
classification type, and the mask bits that can be entered for each classifier associated with that
parameter.
profile‐index Specifies a policy profile number to which this rule will be assigned.
Policy profiles are configured with the set policy profile command as
described in “
set policy profile ” on page 11‐3. Valid profile‐index values
are 1‐ 255.
ether Classifies based on type field in Ethernet II packet.
icmptype Classifies based on ICMP type.
ipproto Classifies based on Protocol field in IP packet.
ipdestsocket Classifies based on destination IP address with optional post‐fixed port.
ipsourcesocket Classifies based on source IP address, with optional post‐fixed port.
iptos Classifies based on Type of Service field in IP packet.
macdest Classifies based on MAC destination address.
macsource Classifies based on MAC source address.
tcpdestport Classifies based on TCP destination port.
tcpsourceport Classifies based on TCP source port.
udpdestport Classifies based on UDP destination port.
udpsourceport Classifies based on UDP source port.
data Specifies the code for a predefined classifier. This value is dependent on
the classification type entered. Refer to
Table 11‐30 for valid values for
each classification type.
mask mask (Optional) Specifies the number of significant bits to match, dependent on
the data value entered. Refer to
Table 11‐30 for valid values for each
classification type and data value.
vlan vlan Classifies to a VLAN ID.
cos cos Specifies that this rule will classify to a Class‐of‐Service ID. Valid values
are 0 ‐ 4095. A value of ‐1 indicates that no CoS forwarding behavior
modification is desired. (Not supported on B3, C3, and G3.)
drop | forward Specifies that packets within this classification will be dropped or
forwarded.
Table 11-30 Valid Values for Policy Classification Rules
Classification Rule Parameter data value mask bits
ether Type field in Ethernet II packet:
1536 - 65535 or 0x600 - 0xFFFF 1- 16