Enterasys Networks D-Series - Manual (Page 148)

set port trap
6-22 Port Configuration
Defaults
If port‐string is not specified, the trap status for all ports will be displayed.
Mode
Switch command, read‐write.
Example
This example shows how to display link trap status for fe.3.1 through 4:
D2(su)->show port trap fe .3.1-4
Link traps enabled on port fe .3.1.
Link traps enabled on port fe .3.2.
Link traps enabled on port fe .3.3.
Link traps enabled on port fe .3.4.
set port trap
Use this command to enable of disable ports for sending SNMP trap messages when their link
status changes.
Syntax
set port trap port-string {enable | disable}
Parameters
Defaults
Sending traps when link status changes is enabled by default.
Mode
Switch command, read‐write.
Example
The following example disables sending trap on fe.3.1.
D2(su)->set port trap fe .3.1 disable
show linkflap
Use this command to display link flap detection state and configuration information.
Syntax
show linkflap {globalstate | portstate | parameters | metrics | portsupported |
actsupported | maximum | downports | action | operstatus | threshold | interval]
| downtime | currentcount | totalcount | timelapsed | violations [port-string]}
port‐string Specifies the port(s) for which to enable or disable port traps. For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 6‐1.
enable | disable Enables or disables sending trap messages when link status changes.