Enterasys Networks D-Series - Manual (Page 331)

Assigning Ports to Policy Profiles
Enterasys D-Series CLI Reference 11-15
Assigning Ports to Policy Profiles
Purpose
To assign and unassign ports to policy profiles.
Commands
set policy port
Use this command to assign ports to a policy profile.
Syntax
set policy port port-string profile-index
Parameters
Defaults
None.
Mode
Switch command, read‐write.
Example
This example shows how to allow Gigabit Ethernet ports 5 through 15 in slot 1 to transmit frames
according to policy profile 1:
D2(su)->set policy port ge.1.5-15 1
Note: The D2 switch supports up to eight user policies per port.
For information about... Refer to page...
set policy port 11-15
clear policy port 11-16
port‐string Specifies the port(s) to add to the policy profile. For a detailed description
of possible port‐string values, refer to “
Port String Syntax Used in the CLI ”
on page 6‐1.
profile‐index Specifies the ID of the policy profile (role) to which the port(s) will be
added. This value must match the profile‐index value assigned using the
set policy profile command (“
set policy profile ” on page 11‐3) in order
for a policy profile to be active on the specified port.