Enterasys Networks D-Series - Manual (Page 136)

Setting Speed and Duplex Mode
6-10 Port Configuration
Setting Speed and Duplex Mode
Purpose
To review and set the operational speed in Mbps and the default duplex mode: Half, for half
duplex, or Full, for full duplex for one or more ports.
Commands
show port speed
Use this command to display the default speed setting on one or more ports.
Syntax
show port speed [port-string]
Parameters
Defaults
If port‐string is not specified, default speed settings for all ports will display.
Mode
Switch command, read‐only.
Example
This example shows how to display the default speed setting for 1‐Gigabit Ethernet port 14 in
slot 3:
D2(su)->show port speed ge.3.14
default speed is 10 on port ge.3.14.
Note: These settings only take effect on ports that have auto-negotiation disabled.
For information about... Refer to page...
show port speed 6-10
set port speed 6-11
show port duplex 6-11
set port duplex 6-15
port‐string (Optional) Displays default speed setting(s) for specific port(s). For a
detailed description of possible port‐string values, refer to “
Port String
Syntax Used in the CLI ” on page 6‐1.