Enterasys Networks D-Series - Manual (Page 116)

show lldp port remote-info
5-20 Discovery Protocol Configuration
show lldp port remote-info
Use this command to display the remote system information stored for a remote device connected
to a local port. You can use this information to detect misconfigurations or incompatibilities
between the local port and the attached endpoint device (remote port).
Syntax
show lldp port remote-info [port-string]
Parameters
Defaults
If port‐string is not specified, remote system information will be displayed for all ports.
Mode
Switch command, read‐only.
PoE Power Source LLDP-MED Extensions Extended Power via MDI TLV. Displayed only
when a port has PoE capabilities. Value can be primary or backup,
indicating whether the PSE is using its primary or backup power source.
PoE MDI Supported/Enabled IEEE 802.3 Extensions Power via MDI TLV. Displayed only when a port
has PoE capabilities. Indicates whether sending the Power via MDI TLV is
supported/enabled. Value can be yes or no.
PoE Pair Controllable/Used IEEE 802.3 Extensions Power via MDI TLV. Displayed only when a port
has PoE capabilities. Indicates whether pair selection can be controlled on
the given port (refer to RFC 3621). Value for Controllable can be true or
false. Value of Used can be signal (signal pairs only are in use) or spare
(spare pairs only are in use).
PoE Power Class IEEE 802.3 Extensions Power via MDI TLV. Displayed only when a port
has PoE capabilities. Indicates the power class supplied by the port. Value
can range from 0 to 4.
PoE Power Limit (mW) LLDP-MED Extensions Extended Power via MDI TLV. Displayed only
when a port has PoE capabilities. Indicates the total power the port is
capable of sourcing over a maximum length cable, based on its current
configuration, in milli-Watts.
PoE Power Priority LLDP-MED Extensions Extended Power via MDI TLV. Displayed only
when a port has PoE capabilities. Indicates the power priority configured
on the port. Value can be critical, high, or low.
Table 5-4 show lldp port local-info Output Details (Continued)
Output Field What it Displays...
port‐string (Optional) Displays remote system information for one or a range of
ports.