Yaskawa MP900 Series Machine Controller for Standard Operation - Manual (Page 401)

Ladder Logic Programming
7.3.6 Editing Programs
7-34
7
„ Cutting
Instructions can be cut. Cut data is copied to the clipboard. The contents of the clipboard can
be reproduced multiple times using the paste operation.
The procedure to cut instructions is outlined below.
1. Move the cursor to the start of the section to be cut.
2. Select Edit (E) and then Cut (X) from the programming menus. "CUT" will appear at
the bottom of the window to indicate the cut operation is in progress.
3. Move the cursor to the end of the section to be cut. The section to be cut will be dis-
played in reversed color.
4. Select Edit (E) and then Cut (X) from the programming menus.
The section specified in 1 and 3 will be cut.
1 Press the ESC Key to cancel the cut operation without cutting any instructions.
2 Unlike the delete operation, power lines will not be corrected when instructions are cut using the cut
operation.
„ Copying
Instructions can be copied to the clipboard. The contents of the clipboard can be reproduced
multiple times using the paste operation.
The procedure to copy instructions to the clipboard is outlined below.
DB001020 IB00100 OBC0010
DB001020 IB00110 OBC0410
DB001020 IB00110 OBC0410
DB001020 IB00100 OBC0010
DB001020 IB00110 OBC0410
Delete
UNDELETE (Edit (E) - UNDELETE (Z)
INFO