Yaskawa MP900 Series Machine Controller for Standard Operation - Manual (Page 158)

3.5 MP920 Module Definitions
3-63
3
260IF Module.
The I/O start and end register addresses must be set in the 260IF Module settings. Allo-
cate the I/O register addresses to be used within the ranges shown below.
2. Double-click the slot set for the 260IF Module to open the 260IF Definitions Window.
Fig 3.12 260IF Definitions Window
„ Setting Methods
The 260IF Definitions Window consists of the following three tab pages.
--- MP920 MP940D
I/O Start Register (IW/OW Register Start Offset) 0000 to 13FF 0000 to 07FF
I/O End Register (IW/OW Register End Offset) 0000 to 13FF 0000 to 07FF
Tab Page Details
Transmission
Parameters Sets the communications and network parameters for the 260IF
Module.
I/O Status Displays the communications status with the slaves when setting the
online master. For details, refer to Chapter 6 Network Maintenance
in the MP900 Series Machine Controller User’s Manual: 260IF
DeviceNet (SIEZ-C887-5.2).
Status Displays the 260IF Module status when online. For details, refer to
Chapter 6 Network Maintenance in the MP900 Series Machine Con-
troller User’s Manual: 260IF DeviceNet (SIEZ-C887-5.2).
Transmis-
sion Param-
eters
I/O Status Status