Grass Valley EDIUS Pro v.7.4 Reference Manual - Manual (Page 79)

Chapter 3 Edit Settings — [System Settings]
79
[Render Options] Select the rendering target. For example, if you check [Filters] and a rendering option is set
when a filter is applied on a clip placed on the timeline, the area of that clip changes color to
yellow. By unchecking [Filters], the area will not change color to yellow. By default, all items
below are checked.
“Color Coding of Time Scale” (w page 278)
[Filters]
Select video filters as the rendering target.
[Transition/CrossFades]
Select transitions and title mixers as the rendering target.
[Key/Transparency]
Select key effect and transparency (when changed from the default) as the rendering target.
[Speed Change]
Select clips that feature any speed adjustments from the default value of 100% as the
rendering target.
[Contents that are not in the Project Format]
Select clips matching any of the following formats as the rendering target:
f Frame size different from that in the project
f Aspect ratio different from that in the project
f Frame rate different from that in the project
f Field order different from that in the project
f Compression format different from format handled by codec specified in the project settings
f Clip including alpha information
[Render Decisions] Check this item to perform rendering when the buffer becomes less than the set value in
[Buffer Left: Fewer than] at playback.
[Buffer Left: Fewer than]
Set the left of buffer value to be referenced for rendering decisions.
[Delete Invalid Rendered Files] Select the timing to delete rendering files.
f “Rendering Overload Areas of the Entire Sequence” (w page 279)
f “Rendering Overload Areas between In and Out Points” (w page 279)
4)
Click [OK].
f You can continue to set other items by clicking [Apply].
[Profile]
Register editing environments as profiles and manage these profiles.
“Editing Environment Management” (w page 104)
[Project Preset]
Create new project presets and manage project presets.
“Creating New Project Presets” (w page 51)
[Loudness Meter]
You can register reference to be used at the loudness measurement as a preset.
1)
Click [Settings] on the menu bar, and click [System Settings].
2)
Click the [Application] tree, and click [Loudness Meter].
3)
Click [Add].
4)
Set each item.
[Preset Name] Enter the name of the sequence.
[Momentary Gating] Enter the measurement time for the momentary value.
[Short-term Gating Block Size] Enter the measurement time for the short-term value.
[Overlap] Enter the overlap value.
[Relative Gating threshold] Enter the relative gating block level.
[Target Level] Enter the target level.
[Meter range] Set the meter range.