Grass Valley EDIUS Pro v.7.4 Reference Manual - Manual (Page 315)

Chapter 7 Applying Effects — Setting Effects
315
2)
Drag and drop [Stabilizer] to the clip on the timeline.
f Analysis of the video motion of the clip starts in the background.
“[Background Job]” (w page 95)
1 Alternative
f Select a clip on the timeline. Select [Stabilizer] in the [Effect] palette, and click [Add to Timeline].
f Select a clip on the timeline. Right-click [Stabilizer] in the [Effect] palette, and click [Add to Timeline].
f Select [Stabilizer] in the [Effect] palette, right-drag it to the clip on the timeline, and click [Add] or [Replace].
3)
Play back a clip to check the video.
f For the part where analysis is completed, the camera shake correction is performed on the spot during playback. Change the camera
correction setting after step 4), if necessary.
4)
Display the [Information] palette, and double-click [Stabilizer].
f The [Video Stabilizer] dialog box appears.
“[Video Stabilizer] Dialog Box” (w page 315)
5)
Configure the settings and click [OK].
[Video Stabilizer] Dialog Box
[Smoothness] Move the slider to adjust the smoothness level of the video motion.
Items set to [Off] are not corrected.
[Translate]
Adjust correction level for vertical and horizontal shake.
[Scale]
Adjust correction level for zoom-in and zoom-out shake.
[2D Rotate]
Adjust correction level for rotation shake.
[3D Rotate]
Adjust correction level for perspective shake.
[Rolling Shutter]
Adjust correction level for distortion of the rolling shutter.
[Auto Trimming] Check this item to enlarge the video automatically in order not to make a gap at the edge of the
video after correcting the video.
You can also enter a value for enlargement factor.
[Preview] Display the corrected video on the entire screen or at the left/right/upper/lower screen, and
compare with the original video. Click the button to select where to display the video.
You can enter a value for the ratio to display the corrected video against the entire screen.
Adjusting Video Drift in Stereoscopic Clips
[Stereoscopic Adjuster]
Adjust drift between the video of the L and R sides of the stereoscopic clip.
Leave the drift only in the horizontal direction for the L side and R side videos. Adjust the video so that no drift exists in the vertical or
rotation direction.
Before operation, read “Notes on Stereoscopic Editing”.
“Notes on Stereoscopic Editing” (w page 298)
1)
In the folder view of the [Effect] palette, click the [Video Filter] tree and display the filters.
2)
Drag and drop [Stereoscopic Adjuster] to the clip on the timeline.
1 Alternative
f Select a clip on the timeline. Select [Stereoscopic Adjuster] in the [Effect] palette, and click [Add to Timeline].
f Select a clip on the timeline. Right-click [Stereoscopic Adjuster] in the [Effect] palette, and click [Add to Timeline].
f Select [Stereoscopic Adjuster] in the [Effect] palette, and right-drag it to the clip on the timeline, and click [Add] or [Replace].