Grass Valley EDIUS Pro v.7.4 Reference Manual - Manual (Page 162)

Chapter 4 Importing Sources — Importing Files from Source Browser
162
2
f For more information on the IEEE1394 connection method, see the manual packaged with XDCAM.
f The SAM mode is supported.
3 Note
f The drivers provided with the XDCAM device must be installed in advance.
1)
Click the [XDCAM] tree in the folder view of the source browser.
2)
Click the drive or reference folder.
f The XDCAM sources are displayed in the clip view.
2
f Reference folders can be temporarily added in the folder view of the source browser. Right-click [XDCAM] and click [Open Folder].
f When references have been temporarily added in the source browser, they can be deleted by right-clicking a folder and clicking [Delete].
Actual folders are not deleted.
f To update the information of references, right-click [XDCAM] and click [Refresh]. If it takes time to display the thumbnail for a clip, press
[Esc] on the keyboard to stop refreshing of the list.
3)
Select the clip to import, and click [Add and Transfer to Bin] in the source browser.
f Data transfer to the PC is started in the background at the same time that the clip is registered to the bin.
“Checking the Progress of Background Jobs” (w page 164)
f The clip can be edited with EDIUS even during transfer.
1 Alternative
f Right-click the clip to import, and click [Add and Transfer to Bin] → a clip type.
2
f Partial transfer is available, where In and Out points are set to files on the XDCAM device and only required parts are transferred to the
hard disk. A message will appear if no connection has been made to the directory where the high-resolution data is saved when partial
transfer is performed on the XDCAM clip. Insert the disk, and click [OK].
“Transferring Only Necessary Parts” (w page 167)
Importing XDCAM Sources from a Server
Import XDCAM sources via FTP, and register them to the bin.
Import settings can be checked and changed by [Importer/Exporter] in [System Settings] → [XDCAM] → [Browser].
“XDCAM Browser Settings” (w page 88)
3 Note
f Set up the FTP server connection in advance.
“XDCAM Connection Settings” (w page 88)
1)
Click the [XDCAM] tree in the folder view of the source browser.
2)
Click the server.
f Information on the server is displayed in the clip view.
2
f To update the information of the server, right-click the connection destination, and click [Refresh].
3)
Select the clip to import, and click [Add and Transfer to Bin] in the source browser.
f Data transfer to the PC starts in the background at the same time that the clip is registered to the bin.
“Checking the Progress of Background Jobs” (w page 164)
f The clip can be edited with EDIUS even during transfer.