Grass Valley EDIUS Pro v.7.4 Reference Manual - Manual (Page 429)

Chapter 10 Export of Edited Contents — Exporting to Tape
429
4)
Recording by the analog device stops.
Exporting to a VARICAM Device
You can export clips edited with EDIUS to an AJ-HD1400 or AJ-HD1200A connected to the PC via an IEEE1394 cable.
3 Note
f You need to register the export destination VARICAM device as a device preset in advance.
“Registration of Device Presets” (w page 115)
f Export cannot be performed if the output format of the device preset for the VARICAM device differs from the current project settings.
f The audio sampling rates will differ for frame frequencies of 59.94 Hz and 60.00 Hz.
f If the frame rate is changed in 1 shot, the lip sync will be out of sync. If necessary, sync the lip sync with waveform editing software
then export.
1)
Click [Export] on the Recorder.
2)
Click [Print to Tape] or [Print to Tape (Display Timecode)].
1 Alternative
f Click [File] on the menu bar, and click [Export] → [Print to Tape] or [Print to Tape (Display Timecode)].
f Exporting to tape: [F12]
2
f If the message [There is no output preset to match the project settings.] is displayed, match the device preset format to the project
settings.
3)
Select a device preset, and click [Next].
f The device presets that can be export with the current project settings are displayed.
4)
Click [Next].
2
f To specify the start position to print to tape, check [Rec In] and enter the timecode. If you click [Read TC from VCR], you can import the
current timecode from the tape.
5)
Confirm the details, and click [Export].
f Timeline playback and export start.
f The [Print To Tape] dialog box disappears when the export finishes.
2
f Click [Cancel] to abort the export.
f If In and Out points have been set on the timeline, that range will be exported.