Grass Valley EDIUS Pro v.7.4 Reference Manual - Manual (Page 218)

Chapter 6 Editing Timelines — Placing Clips
218
1)
Select a clip, click [Marker] on the menu bar, and click [Set In/Out Point to Selected Clip].
f In and Out points are set to both ends of the clip.
1 Alternative
f Setting In and Out points to both ends of a selected clip: [Z]
Deleting the In and Out Points on the Timeline
You can delete In and Out points on the timeline.
1)
Click the [Set In] ([Set Out]) list button on the Recorder.
2)
Click [Clear In Point] ([Clear Out Point]).
1 Alternative
f Right-click the time scale, and click [Clear In Point] ([Clear Out Point]).
f Click [Marker] on the menu bar, and click [Clear In Point] ([Clear Out Point]).
f Right-click the slider on the Recorder, and click [Clear In Point] ([Clear Out Point]).
f Deleting In and Out Points on the timeline: [Alt] + [I]/[Alt] + [O]
2
f You can delete In and Out points in a single operation by the following operation:
g Right-click the time scale, and click [Clear In/Out Point].
g Click [Marker] on the menu bar, and click [Clear In/Out Point].
g Deleting In/Out points: [X]
Placing Clips
Placing Clips
You can place source clips on the timeline.
Clip operations at placement and placement results are dependent on the editing mode.
“Switching the Editing Mode” (w page 210)
1)
Set the source channel mapping.
f “Setting Channel Mapping” (w page 215)
2)
Move the timeline cursor to the position to place the clip.
3)
Select a clip from the bin, and click [Add to Timeline].
f The clip is placed on the track with the position of the timeline cursor set as the In point.