Grass Valley EDIUS Pro v.7.4 Reference Manual - Manual (Page 290)

Chapter 6 Editing Timelines — Multicam Mode
290
2)
Right-click the time scale, and click [Add Cut Point/Clear Cut Point (Toggle)].
f The camera switch point is set at the timeline cursor position, and a cut point is added to the clip on the switch point.
f Repeat steps 1) and 2), to set the camera switch point. The enable/disable setting of clips to use can be set by switching the selected
camera.
“Switching the Selected Camera” (w page 292)
“Clip Enable/Disable” (w page 232)
1 Alternative
f Double-click the time scale at the position to set the camera switch point.
f Double-click the camera video of each track.
f Setting camera switch point: [0]
2
f The same operations can also be performed during playback.
Setting the Camera Switch Point during Playback
You can set the camera switch point during playback. Playback operations are the same as in the standard mode.
The following explains operations in the divided screen in the multicam mode. When display of only the selected camera in the single mode
has been set, operate using the numerical keypad on the keyboard.
“Multicam Editing by Shortcut Keys” (w page 293)
1)
Move the timeline cursor to the position to start playback.