Grass Valley EDIUS Pro v.7.4 Reference Manual - Manual (Page 115)

Chapter 3 Edit Settings — External Device Management
115
1)
Right-click a blank area in the device preset list, and click [Import].
f “[Device Preset] Screen” (w page 110)
2)
Select a file, and click [Open].
f The imported preset is displayed in the device preset list.
Exporting Device Presets (Export)
Export device presets.
1)
Select and right-click a preset in the device preset list, and click [Export].
f “[Device Preset] Screen” (w page 110)
2)
Select a save destination and click [Save].
Assigning Device Presets to Input Presets
If you assign device presets as input presets in advance, an assigned device preset can simply be called up at capture.
1)
Select and right-click a preset in the device preset list, and click [Assign Input Preset] → [Input
Preset 1] - [Input Preset 8].
f “[Device Preset] Screen” (w page 110)
f The selected device preset is assigned as an input preset, and is displayed as an input preset when [Capture] on the menu bar is clicked.
2
f To cancel an assignment to an input preset, right-click a blank area in the [Device Preset] list, and click [Delete assignation] → preset
name.
Points About Input from VARICAM Devices
Import and edit video shot on VARICAM devices on EDIUS.
The following explains points when using VARICAM devices to input/output video.
Points About Project Settings
When [TC preset] in the project settings is set to other than “00”, the sequence of active frame information may not match the TC at stream
output.
“[Project Settings] (Detailed Settings) Dialog Box” (w page 44)
When the frame rate of the source does not match the frame rate of the project, the pitch is altered so that the audio speed is changed to
keep up with playback duration. If necessary, make adjustments in the waveform editing software or the pitch shifter of the audio filter.
Registration of Device Presets
Before using VARICAM devices to input/output video, register VARICAM devices connected to the PC via the IEEE1394 interface in
advance as device presets.
To connect the AJ-HD1200A via the IEEE1394 interface, the option board must be attached.
The following explains points when registering VARICAM devices as device presets. For details about the procedure for registering device
presets and other information, see “Registering Device Presets”.
“Registering Device Presets” (w page 109)
When setting [Video Format] at [Input H/W, Format Settings] in the Preset Wizard, refer to the explanation about each of the following
formats:
1280x1080 59.94i
1440x1080 50i
When importing from DVCPRO HD standard-compliant equipment, select the format that
matches the respective frame frequency setting used when the video was shot.
960x720 59.94p Use this when capturing sources taken with VARICAM without referencing active frame
information or when capturing content taken with AJ-HDX900, for example, whose format
signals are 720/59.94p, 720/29.97p or 720/23.98p.