Grass Valley EDIUS Pro v.7.4 Reference Manual - Manual (Page 232)

Chapter 6 Editing Timelines — Clip Operations
232
Combining Divided Clips
You can recombine divided clips.
1)
Select 2 clips to be combined.
2)
Click the [Add Cut Point (Selected Tracks)] list button on the timeline.
3)
Click [Remove cut points].
f The 2 clips are combined, and can be handled as a single clip.
1 Alternative
f Right-click a clip and click [Remove cut points].
f Click [Edit] on the menu bar, and click [Remove cut points].
f Deleting cut point: [Ctrl] + [Delete]
2
f Three or more clips can be combined with the same operation.
3 Note
f [Remove cut points] is available only when neighboring clips are referencing the same source.
f When combining clips, if individual effects (e.g. video filter) or layouts have been applied to the clips before combining, the effect of
clips placed to the leftmost side of the timeline are applied to clips after combining and other effects are deleted.
f The two clips before combining cannot be combined if their playback speed is different. Also, the settings of clips from the second clip
from the left and onwards are discarded if a time remap has been set.
f When combining clips, the rubber band setting before combining is maintained. Note, however, that priority is given to the settings of
subsequent clips when the rubber band points of the combined section are out-of-position.
Preventing Playback of Clips
Clip Enable/Disable
You can disable clips placed on the timeline. Disabled clips cannot be played back.
1)
Right-click the clip to disable, and click [Enable/Disable].
f Disabled clips are displayed in gray regardless of their type.
1 Alternative
f Select the clip to disable, click [Clip] on the menu bar, and click [Enable/Disable].
f Enabling/disabling clips: [0]