Grass Valley EDIUS Pro v.7.4 Reference Manual - Manual (Page 221)

Chapter 6 Editing Timelines — Placing Clips
221
3)
Set the In and Out points to the timeline.
f “Setting the In and Out Points on the Timeline” (w page 217)
4)
Click [Insert to Timeline] on the Player.
f The clip is placed trimmed to the length between In and Out points on the timeline. When the In point has been set, it is placed referenced
to the In point.
f The playback speed of the placed clip remains unchanged.
f When [Overwrite to Timeline] is clicked, the clip is placed in the overwrite mode.
Placing the In and Out Points of Clips between In and Out Points on the Timeline (4 Point
Editing)
Set the In and Out points to the clip, and place it between In and Out points on the timeline. The speed between In and Out points of the clip
is adjusted automatically according to the length between In and Out points on the timeline.
1)
Select a clip from the bin, and click [Show in Player].
f The same operations can also be performed in the source browser.
2)
Set the In and Out points to the clip.
f “Setting the In and Out Points” (w page 171)
3 Note
f Even if a margin is not assigned to a source, set the In and Out points to the start and end of the source. The editing mode becomes
3-point editing when In and Out points are not set.
3)
Setting the Source Channel Mapping
f “Setting Channel Mapping” (w page 215)
4)
Setting the In and Out Points to the Timeline
f “Setting the In and Out Points on the Timeline” (w page 217)
5)
Click [Insert to Timeline] on the Player.
f The In and Out points of a clip are placed between In and Out points on the timeline.
f When [Overwrite to Timeline] is clicked, the clip is placed in the overwrite mode.
3 Note
f When the duration between In and Out points on the timeline differs from that between In and Out points of the clip, the playback
speed of the clip is adjusted automatically to stay between In and Out points on the timeline, with the range between In and Out points
maintained.
Previewing Cut Switch Points (Preroll Edit (Preview))
Before placing clips, you can preview where cuts are switched.
Before operation, set to the overwrite mode.
“Insert/Overwrite Mode” (w page 210)