Toa N-8000 Series - Manual (Page 98)

1-81
Chapter 1 GENERAL DESCRIPTION
9.3. Station Paging Receiving Mode
The station that receives Station Paging operates in either Conversation priority mode or Paging priority mode
as described below. However, when the exchange to which the station connects is the N-8010EX, the mode is
fixed to the Conversation priority mode.
Use the supplied N-8000 Setting Software for the mode setting.
Note
All stations in a corresponding zone can receive Emergency paging calls, Message pagings or external
input broadcasts for which priority has been switched ON, regardless of the stations' reception mode setting.
Interrupted functions are not restored.
9.3.1. Conversation priority mode
• When a paging is made, the station in standby mode receives it. If it is engaged in conversation or dialing, it
does not receive the paging.
• Even when a station is called while being paged, it continues to receive paging without being placed in called
status. In this case, the calling party hears a busy tone.
When a paging arises on a station being engaged in conversation and still continues after the conversation
is over, the station starts receiving the paging on completion of the conversation.
Note
Dialing is possible even while receiving a paging.
9.3.2. Paging priority mode
• When a page is made, the station in standby mode receives it. If paged during a conversation, the paged
station receives the page without terminating the current conversation, while a holding tone is transmitted to
the conversation partner during a conversation between paging and paged parties if the paging station does
not belong to the same paging zone.
• When the station being paged receives a call from another station, the paged station becomes busy and
maintains the paging. When the call to the station maintains after paging completion, the station receives the
call.
Note
Dialing is impossible while receiving a page. (Paging response cannot be performed at a paging receiving
station, either.)