Toa N-8000 Series - Manual (Page 113)

2-2
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
MASTER STATION'S
FUNCTIONS AND OPERATION
1. BASIC USAGE
Operation is the same for both the stations connected to the exchange and the IP stations connected to a LAN,
and also for the N-8031MS Hands-free Master Station used in combination with the RS-191 Handset.
1.1. Calling from a Master Station (Individual Calls)
Step 1. Press the station number to be called.
In this case, the station's handset may be either
lifted or in place.
The call tone is heard through the calling station's
internal speaker (heard in the handset speaker if the
handset is lifted).
When a busy tone is heard, wait till the line becomes
free, and you are automatically connected to the
called party.
Step 2. Start conversations when the call tone stops and the
called party answers.
Note
When the system is set to "Sequential Response*"
and the called station set to "Automatic Connection
Mode*," it is possible to start conversations after a
brief ring tone is sounded once. In other settings,
the call tone continues to sound and stops when
the called party answers, allowing conversations to
start.
Step 3. To finish conversations, press the Clear key or
replace the handset.
* Use the supplied N-8000 Setting Software to perform Sequential response and Incoming call mode setting.
(Refer to p. 5-26 , 5-65 , 5-80 .)
Note
If the system has been set for call time-out or conversation time-out, the call or conversation automatically
stops after the specified time limit. The specific length of this time-out (in 10-second units between 10 and
990 seconds) is preprogrammed into individual exchanges or IP stations using the supplied N-8000 Setting
Software. (Refer to 5-36 , 5-54 , 5-63 , 5-98 . )
or
1 5 1 5
Call tone
Call tone
or
Master station Master station
or
or
C