Toa N-8000 Series - Manual (Page 464)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
Sub-station Interface: Function Settings
5-54
5.6.2. Function settings
Step 1. Click "Function Settings" tab to display the following setting screen.
Step 2. Set individual items.
(1) Transfer settings (N-8400RS only)
Set the transfer function ON or OFF for the station connected to the exchange.
Call forwarding: Calls to stations are automatically transferred to another designated station
without sounding a call tone only when Call forwarding function is enabled.
Time-based call forwarding: Calls to stations are automatically transferred to another designated station
without sounding a call tone only when the preset time is reached.
This function can be set only when the call forwarding function is enabled.
Preset time can be set only when the time-based call forwarding function is
enabled.
Group hunting: Calls to a busy station are automatically transferred to another designated
station, if group hunting function is set to the called station.
Absence transfer: When no response is made to a call to the station for a set period of time,
the call is automatically transferred to another designated station. Preset
time duration can be set only when the absence transfer mode is enabled.
(2) Time limit
Set the time-out value for calling, conversation or paging functions in ten-second units between 10 and 990
seconds.
Call time-out: Set whether to limit the duration of a call to the station. If setting a timeout, enter
the time limit after which calls to the station are automatically terminated. If not
setting a timeout, calls will continue until they are cancelled or the called station
responds.
Conversation time-out: Set whether to limit the duration of conversations with the station. If setting a timeout,
enter the time limit after which conversations to the station are automatically
terminated. If not setting a timeout, conversations will continue until executing the
termination operation.