Toa N-8000 Series - Manual (Page 393)

4-5
Chapter 4 SYSTEM DESIGN FLOW
5. SYSTEM SETTING ITEMS AND DEFAULT
All system setting items except the auto-dialing programming can be set using the N-8000 Setting Software.
Some setting items, however, can also be set on the browser or at stations. The browser can only make the
connected Exchange-, Various kinds of interface units-, or IP station-related items, while stations can only
make the connected Exchange- or their own stations-related items.
The following tables, classified according to the system setting items on the N-8000 Setting Software, show
items, their default, and reference pages in this manual.
Note: In "Reference page" column, "SW" represents the software, "BR" represents the browser, and "ST"
represents a station.
5.1. General System
Side TAB Item Default
Reference
page
Equipment Registration Contents
-
p. 5-20
Equipment number 1 – p. 5-20
Equipment name * 1 Each unit's
model No.
(Example: N-8000EX)
SW: p. 5-20
BR: p. 6-5
Station Table Station number digits 2 p. 5-22
Station number * 2 Line 1: 10,
Line 2: 11, .... ,
Line 16: 25
SW: p. 5-22
ST: p. 7-9
Station name
-
p. 5-23
Network communications
ON or OFF between
exchanges
-
p. 5-24
Multicast communications
ON or OFF between
exchanges
-
p. 5-25
System Settings Response Mode Sequential
p. 5-26
Clock Master
-
NTP client
-
Time Signal
-
DST (Summer time) OFF
p. 5-27
DST start time 1/1 0:00
DST end time 1/1 0:00
NTP server address
-
NTP server port
-
NTP sync time 2:45
Clock sync time 3:00
C/O control password 0000
Maintenance Password
-
Gateway Settings Enable/Disable the SX System Disable
p. 5-28 SX-200IP connection
-
ID (SX) : Slot
-
• All of the above items can be set on the N-8000 Setting Software.
* 1 Settings possible from a browser as well.
* 2 Settings possible from a station as well only when it is the N-8000MS Multifunctional master station or
N-8500MS/8600MS IP Multifunctional master station.