Toa N-8000 Series - Manual (Page 428)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
5-18
5.2. Menu
5.2.1. File
New : Creates the setting file for a new system.
Open : Opens the stored setting file.
Save : Saves the setting file currently being edited.
Save As : Saves the setting file being edited as a file for the different system by renaming it.
Print: Prints the set data of the system.
Close : Terminates this software program.
5.2.2. Configuration
Upload : Writes settings data to equipment.
Download : Downloads equipment settings data to a PC.
Export : Outputs the setting files. (*.pi8/*.cfg)
Firmware Version Check : Verifies the device’s firmware version. If a device is detected to be using a firmware
version earlier than 2.00, the firmware can be updated to version 2.00.
(7) C/O Interface tab
Perform settings related to the C/O interface
unit. Available tabs include: [Network Settings],
[Function Settings 1], [Function Settings 2] and
[Scan Monitor].
(8) Telephone Interface tab
Perform settings related to the Telephone
interface unit. Available tabs include: [Network
Settings], [Function Settings 1], [Function Settings
2] and [Scan Monitor].
(9) Audio Interface tab
Perform settings related to the Audio interface
unit. Available tabs include: [Network Settings]
and [Function Settings].
(10) Direct Select tab
Perform settings related to the Direct select
unit. Available tabs include: [Network Settings],
[Function Settings], [Contact Input] and [Contact
Output].
(11) Gateway tab
Perform settings related to the IP module.
Available tab includes: [Network Settings].
(12) paging tab
Used to set paging zones.
(13) Group tab
Perform settings for Group Blocking and Remote
Response group functions. Available tabs
include: [Group Blocking Group], [Group Blocking
To] and [Remote Response Group].