Toa N-8000 Series - Manual (Page 476)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
IP Station: Function Settings 2
5-66
(5) priority call (Selective response mode, Ip door station only)
Call priorities can be adjusted in five increments from 1 (minimum) to 5 (maximum).
Level 5 is the same priority as an emergency call.
The default sensitivity is Level 1.
(6) BGM
Set whether the IP station receives BGM broadcasts. If receiving, place a checkmark and select the BGM
channel number (1 – 8; Channel No.).
(7) Door remote
Set the Multi interface unit's, Direct select unit's, or Audio interface unit’s unit number and contact output
terminal number to be used for door remote control.
(8) Calling station indication/CCTV control
Control output : Set the Multi interface unit's, Direct select unit's, or Audio interface unit’s unit number
and contact output terminal number, which provide a make contact when the station
is called.
Called station's No.: Provides a make contact when the station to be set here is called. Up to 8 stations
can be set.
When the C/O interface unit is set as a called station, enter "#", followed by the
access number. For example, when setting the C/O interface unit with access
number "05," enter "#05".
(Example)
The operation example illustrated below is based on the following settings:
Station No. (for IP station): 148
Control Output
MI Equipment No.: 5
Contact output No.: 6
Called station's No.: 149
(9) Record conversation
Records IP station conversations.
The conversation of the station is provided from the audio output of the designated N-8000AF audio
interface unit.
(10) Speaker selection (N-8640DS/8650DS only)
Select the internal or external speaker to output paging calls or conversations.
Select one from "Always use internal speaker," "External speaker only in paging call," and "Always use
external speaker."
(11) User Access Code (N-8600MS only)
Set whether or not to enable the Access code authentication.
Enter the access code number (4-digit number).
Call
No. 148
No.149
1 4 9
N-8000MI (Equipment No. 5)
Contact Output No. 6
Make contact
The Multi interface unit's (equipment No. 5) Contact No. 6 closes when the station No. 148 calls the station
No. 149.