Toa N-8000 Series - Manual (Page 281)

2-170
Chapter 2 FUNCTIONS AND OPERATION
OPERATION FROM AN OUTSIDE LINE
3.2.4. Reserving the time signal schedule change
The System Time Signal schedule can be reserved through operation from the outside line telephone.
To set the reserved day, designate the day from one (next day) to 9 days later by number (1 − 9) after performing
the reservation operation.
The reserved schedule is executed at 00:00 AM on the reserved day.
[Operation]
Step 1. Lift the handset and dial the N-8000CO's outside line number.
The N-8000CO unit automatically responds to the call and a dial confirmation tone is transmitted to
the caller.
Step 2. After hearing the dial confirmation tone, press the [ ][9][5][Outside Line Control Password* (4 digits)]
[Reserved day (1 − 9)][Schedule No. (01 − 16)] keys in sequence.
The calling party can hear a confirmation tone, and the changed time signal schedule is reserved.
* The outside line control password is required only when it has been set.
0 0
or
Z 9 5 X X
A A
Y Y Y Y
N-8000CO's
outside line number
(Dial
confirmation tone)
Outside line
control password
(Confirmation tone)
Schedule No.
Reserved day
Note
The contents set through operation from the outside line telephone are saved to the N-8000AF unit once a day
(at 00:00 AM).
If the N-8000AF is turned off before the contents are saved, the time signal schedule returns to the setting
contents that were programmed before power-off.
Tip
Following that, the calling party can confirm the changed time signal schedule.
Perform Step 2 in "Confirming the reserved time signal schedule" (refer to p. 2-172 ) within 10 seconds
after a confirmation tone is heard.
The line is cut off if incorrect dialing operation is performed or there is a pause of 10 seconds during
dialing operation.
Step 3. Either replace the handset or press the [0][0][#] keys.