Toa N-8000 Series - Manual (Page 278)

2-167
Chapter 2 FUNCTIONS AND OPERATION
OPERATION FROM AN OUTSIDE LINE
Z Z 9 0
Schedule No.
X X Y Y Y Y (Confirmation tone)
N-8000CO's outside line number
(Dial
confirmation tone)
Outside line
control password
3.2. Time Signal
(only when the N-8000AF is used)
Change, suspension, confirmation, reservation, and reservation confirmation of the time signal schedule can
be made from the outside line telephone when the Direct-In Dialing function is set to the N-8000CO unit.
It is also possible to set an outside line control password to be used when dialing from the outside line telephone.
Use the N-8000 Setting Software to enable or disable the direct-in line function, and setup the outside line control
password. (Refer to p. 5-26 , 5-90 .)
3.2.1. Changing time signal schedules
The System Time Signal schedule can be changed through operation from the outside line telephone.
[Operation]
Step 1. Lift the handset and dial the N-8000CO's outside line number.
The N-8000CO unit automatically responds to the call and a dial confirmation tone is transmitted to
the caller.
Step 2. After hearing the dial confirmation tone, press the [ ][9][0][Outside Line Control Password* (4 digits)]
[Schedule No. (01-16)] keys in sequence.
A confirmation tone can be heard at the calling party, and the time signal schedule changes to the
designated one.
* The outside line control password is required only when it has been set.
or
0 0
Tip
Following that, the calling party can confirm the changed time signal schedule.
Perform Step 2 in "Time signal schedule confirmation" (refer to p. 2-169 ) within 10 seconds after a
confirmation tone is heard.
The line is cut off if incorrect dialing operation is performed or there is a pause of 10 seconds during
dialing operation.
Step 3. Either replace the handset or press the [0][0][#] keys.
Note
The contents set through operation from the outside line telephone are saved to the N-8000AF unit once a day
(at 00:00 AM).
If the N-8000AF is turned off before the contents are saved, the time signal schedule returns to the setting
contents that were programmed before power-off.