Toa N-8000 Series - Manual (Page 248)

2-137
Chapter 2 FUNCTIONS AND OPERATION
N-8000AL TELEPHONE INTERFACE CONNECTED TELEPHONE
2.3. Automatic Transfer
Note
Calls cannot be automatically transferred to the station connected via the multi interface unit or the C/O line
interface unit.
2.3.1. Group hunting
Calls to a busy telephone set for Group hunting are automatically transferred to another designated station or
telephone.
This Group hunting function also applies to the call transfer ( p. 2-15 ) performed during conversation.
When the designated station to which a call was transferred is busy, the call is automatically transferred to the
next designated station, and this continues in series until a free line is found.
Note
The station to which a call is to be transferred can be set either by dialing operation (see below) or using the
supplied N-8000 Setting Software. (Refer to p. 5-99 .)
Use the supplied N-8000 Setting Software to enable or disable the Group hunting function. (Refer to p. 5-97 .)
The station to which a call is to be transferred cannot be designated unless the group hunting function is
enabled.
(Example: A call to the telephone No. 62 will automatically be transferred, if No. 62 is busy, to the next designated
station, No. 63.)
No. 11
No. 62
No. 63
No. 10
6 2
Call tone Call
Conversation
Notes
Calls are not transferred under the following conditions.
• The designated station is set for Call forwarding.
• The designated station is not in standby mode. (However, even when the designated station is busy, if it is set
for Group hunting, the call is further transferred to the next designated station.)
• The station set for Group hunting is called as a representative or its associated member station of the group.