Toa N-8000 Series - Manual (Page 271)

2-160
Chapter 2 FUNCTIONS AND OPERATION
OPERATION FROM AN OUTSIDE LINE
2. PAGING
If the N-8000CO C/O Line Interface Unit is set to receive Direct-In Dialing calls as well operate paging calls,
N-8000 system paging can be initiated from the outside line telephone.
Also, a paging time limit can be set by programming a time limit (in 10 seconds units from 10 − 990 sec.) into
each N-8000CO unit.
Note
Use the N-8000 Setting Software to enable or disable Direct-In Dialing and paging, and set the paging time
limit. (Refer to p. 5-90 .)
2.1. Zone Paging
Paging calls can be made to one of the pre-programmed zones.
Use the supplied N-8000 Setting Software to set the paging zones. (Refer to p. 5-121 .)
Step 1. Lift the handset and dial the N-8000CO's outside line number.
The N-8000CO unit automatically responds to the call and a dial confirmation tone is transmitted to
the caller.
Step 2. After hearing the confirmation tone, press the [ ][8] keys, w then the zone number (1 − 192) to be
paged.
A paging tone is transmitted to the selected zone.
Note
Enter a zone number with the digit length (1 − 3 digits) set by way of the N-8000 Setting Software.
Step 3. Page with the handset.
Note
If the system's paging response mode has been set for Zone number designation response (refer to p.
2-32 ), announce the response zone number to the paged party in the paging message.
Step 4. Either replace the handset or press the [0][0][#] keys.
The paging is completed.
Notes
• A repeated busy tone is heard at paged stations if the handset is replaced to terminate paging.
• If paging is terminated by [0][0][#] key operation, the DTMF signal tones of these keys are heard at
paged stations.