Toa N-8000 Series - Manual (Page 427)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
5-17
5. SYSTEM SETTING FUNCTION
Performs individual system settings. Use the Unit Scan/Network Setting function, a browser, an N-8000MS
Multifunctional station, or an N-8500MS/8600MS IP Multifunctional station to set the IP address correctly, then
use this System Setting function to update the exchange's, various kinds of interface units, or IP station's setting
data.
5.1. Screen Description
Click [System Settings] on the initial screen.
(1) General tab
Performs settings related to the overall
system configuration. Available tabs include:
[Equipment Registration], [Station Table],
[Network Communication Registration], [Multicast
Registration], [System Settings] and [Gateway
Settings].
(2) Exchange tab
Performs settings related to the exchange.
Available tabs include: [Network Settings],
[Sampling Frequency Correction] and [Function
Settings].
(3) Multi Interface tab
Perform settings related to the multi interface
unit. Available tabs include: [Network Settings],
[Sampling Frequency Correction], [Function
Settings], [Audio I/O], [Contact Input] and [Contact
Output].
(4) Sub-station Interface tab
Perform settings related to the Sub-station
interface unit. Available tabs include: [Network
Settings], [Function Settings] and [Sub-Station
Settings].
(5) Ip Station tab
Perform settings related to the IP station. Available
tabs include: [Network Settings], [Function Settings
1], [Function Settings 2], [Speed Dialing], [Scan
Monitor] and [Message Paging].
(6) Station tab
Perform settings related to the station connected
to the exchange and the analog master station
connected to the Substation interface unit.
Available tabs include: [Function Settings], [Speed
Dialing] and [Scan Monitor].
Note
The screen above represents the state when settings for 15 pieces of equipment have been completed.