Toa N-8000 Series - Manual (Page 86)

1-69
Chapter 1 GENERAL DESCRIPTION
Function Description
Reference page
Operation Setting
Other
functions
Time signal
Schedules can be set, changed or suspended. The Time
Signal operates according to programmed schedules.
p. 2-50 p. 5-107
PBX connection
If the Multi interface unit is connected to the PBX’s
analog E&M interface, calls or conversations can be
mutually made between the N-8000 system’s stations
and the PBX’s extension telephones or paging calls can
be initiated from the PBX extension telephone.
p. 2-56 p. 5-45
Outside line
connection
The use of the C/O Line Interface Unit allows the Master
Station to make or receive calls to or from the outside
line telephone.
p. 2-58 p. 5-90
Tie-line
connection
Using the Multi interface unit for tie-line connection
between the N-8000 Series intercom system exchange
and other series intercom system exchanges via 4-wire
private lines permits calls, conversations, or paging to
be mutually made between stations connected to the
tie-lined exchanges.
p. 2-67 p. 5-45
BGM
Connecting playback components to the Multi interface
unit permits Background music selectable from up to 8
programs to be heard from each station speaker while
in standby mode.
p. 2-69
p. 5-36
p. 5-45
p. 5-63
External
equipment
control
Through operation of the station, external equipment
can be controlled by transmitting a one-shot make
output signal or make/break contact signal to the
contact of the designated Multi-Interface, Direct Select
unit, or Audio Interface unit, or by transmitting a one-
shot make output signal to the contact of the designated
door station.
p. 2-71
p. 5-35
p. 5-43
p. 5-49
p. 5-62
p. 5-67
p. 5-82
p. 5-106
p. 5-110
p. 5-114
p. 5-117
Audio trigger
Activates alarm operation if audio input to the
microphone or the preprogrammed N-8050DS Door
Station or N-8640DS/8650DS IP Door station meets
set conditions.
p. 2-78 p. 5-67
p. 5-81
Door remote
control
Electronic locks or other external devices can be
controlled through utilization of the Door Station’s
contact output.
If a Master Station engaged in conversation with a Door
Station activates the Remote Door Control function, the
Door Station’s contact output closes for a specified
period of time. Similarly, the contact output of the Multi-
Interface Unit, the Direct Select Unit, and the Audio
Interface Unit can also be controlled.
p. 2-74
p. 5-35
p. 5-37
p. 5-62
p. 5-64
p. 5-66
p. 5-80
p. 5-97
p. 5-100
IP door station’s
speaker output
switching
control (only
when the
N-8640DS/
8650DS is
used)
The audio output destination of the N-8640DS/8650DS
IP door station engaged in conversations with the
master station can be switched to either the internal
speaker or the speaker connected to the external
speaker terminal by the master station’s dial operation.
The switched audio output destination reverts to the
internal speaker when the conversations terminate or
when interrupted by paging with higher priority.
p. 2-81 p. 5-66
Access code
authentication
Usage of the master station can be restricted when the
access code authentication (4-digit password) is enabled.
If authentication fails, such operations as calling,
scan monitor, and paging calls cannot be made. Call
response and emergency operations are not subject to
access code authentication.
p. 2-82 p. 5-66
p. 5-81