Toa N-8000 Series - Manual (Page 457)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
Multi Interface: Contact Input
5-47
5.5.5. Contact input setting
Step 1. Click "Contact Input" tab. The setting screen is displayed.
Step 2. Set each item of "Contact input."
(1) Contact input No. (Can't be edited.)
The Multi interface unit's contact input terminal number.
(2) Operation mode
Select the contact input's operation mode. The setting contents differ depending on the mode selected
here.
Input interlock level: Select this item when closing the contact output terminal in synchronization with
the contact input terminal as shown below. (The input is defined when its level
remains constant for 50 ms after change.)
Input interlock edge: Select this item when closing the contact output terminal in synchronization with
the contact input terminal as shown below. (The input is defined when its level
remains constant for 50 ms after change.)
[Input interlock level]
ON
Input
OFF
ON
Output
OFF
[Input interlock edge]
ON
Input
OFF
ON
Output
OFF
50 ms 50 ms 50 ms 50 ms