Toa N-8000 Series - Manual (Page 121)

2-10
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
Call
Conversation
Station number where
group calls is set
Any key
Continuous call tone
X X
X
Continuous call tone Continuous call tone
2.2. Setting Call Receiving Modes
(only when the system is set to "Sequential Response" mode)
Call receiving modes, and call tone on/off can be selected for each station.
Use the supplied N-8000 Setting Software to perform the setting. (Refer to p. 5-65 , p. 5-80 .)
2.2.1. Automatic connection
Incoming calls are automatically connected after a brief call tone (about 1 second) or without a call tone.
When a call is received, the status indicator changes from unlit to flashing red. It lights red continuously when
a conversation begins.
Lifting the handset creates a handset conversation.
2.2.2. Continuous call
Calls continue with a continuous call tone (or without a call tone) and a status indicator flashes as long as
there is no answer. When a call is received, the status indicator changes from unlit to flashing red. It lights red
continuously when a conversation begins.
Handset conversation is established when the handset is lifted, and hands-free conversation when any key is
pressed to answer a call (one-touch key response).
Note
The N-8050DS Door Station and N-8540DS/8640DS/8650DS IP Door Station cannot be set for the continuous call mode.
2.1.5. Group calls
• When a station is assigned to group call member station, if the station is called, this station (representative
station) and all member stations are simultaneously called by a continuous call tone regardless of their call
receiving mode settings.
• Even when the representative station is busy, all of the associated member stations within the same group
are called by means of a continuous call tone. This continuous call tone stops when any one of the associated
stations responds to the call.
• Use the supplied N-8000 Setting Software to perform the group call member station setting.
(Refer to p. 5-65 , 5-80 )
Notes
• The N-8050DS Door Station, N-8540DS/8640DS/8650DS IP Door Station, RS-150/160/170/180/450/460
/470/480 Substation, RS-140/143/144 Switch Panel, and RS-142/442 Switch Board cannot be assigned to the
group call representative station nor member station.
• When the call response mode is set to “Selective Response,” the stations connected to the same N-8010EX
Exchange or the N-8400RS Substation Interface Unit cannot be assigned to the group call member stations.