Toa N-8000 Series - Manual (Page 270)

2-159
Chapter 2 FUNCTIONS AND OPERATION
OPERATION FROM AN OUTSIDE LINE
Call
N-8000CO's outside line number
(Dial confirmation tone)
X X
Call tone
Station number (2 – 6 digits)
+ Y Y
OPERATION FROM AN OUTSIDE LINE
(only when the N-8000CO is used)
1. CALLING A STATION
Direct-In Line and Direct-In Dialing functions allow the N-8000 system to receive calls from an outside line
telephone. The method used to call the station differs between the two.
1.1. Direct-In Line Calls
If the N-8000CO C/O Line Interface Unit is set for the Direct-In Line, up to four preprogrammed stations can be
simultaneously called.
Dial the N-8000CO's outside line number.
A call tone is sounded at the four preprogrammed stations.
If one of the four stations responds, the telephone call is put through to that station.
Note
If the called master station does not respond within 30 seconds, the call is disconnected from the line.
Call
N-8000CO's outside line number
X X
Call tone
1.2. Direct-In Dialing Calls
If the N-8000CO C/O Line Interface Unit is set for Direct-In Dialing, a single station is designated and called.
Step 1. Lift the handset and dial the N-8000CO's outside line number.
The N-8000CO automatically responds to the call and a dial confirmation tone is transmitted to the
caller.
Step 2. After hearing the confirmation tone, dial the desired station number to call.
A call tone is sounded at the called station.
When the called party answers, conversation can be started.
Notes
• If there is a pause of 5 seconds during dialing operation, this is regarded as an error, and the attempted
call is disconnected from the line.
• If the called master station does not respond within 30 seconds, the call is disconnected from the
line.