Toa N-8000 Series - Manual (Page 517)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
Audio Interface: Function Settings
5-107
(3) paging
Set the operation mode of the audio interface unit.
Delay Time: Set the delay time before paging is initiated.
Aux input paging priority: Allows external input broadcasts to take precedence over all-zone paging
and individual zone paging.
(4) Input level
Set the audio input sensitivity.
(5) Time sync function
Set the Time sync function.
Adjust enable: Set whether or not to enable the time sync function.
Start time/End time: Set time ranges that make the time sync function operable.
Note
This function cannot be used simultaneously with the NTP Client function.
(6) Time signal
This function sets the schedule for the time signal.
Clicking the "Schedule settings" button displays the schedule setting screen.
Step 3. Set the schedule.
(1) Signal activation time
Set the activation time interval for individual sound sources (1 – 1,024 sec).
Sound source numbers 1 – 5 correspond to an internal sound source, while numbers 6 – 9 correspond to
an external sound source (contact outputs 1 – 4).
3
-1 3
-2