Toa N-8000 Series - Manual (Page 388)

3-84
Chapter 3 INSTALLATION & WIRING
[N-8050DS]
Tighten
Terminal screw
Terminal block
Cable
3
2
Removable terminal plug
(supplied with the N-8031MS/
8033MS)
Pin header
Cable
[N-8031MS/8033MS]
3
4
2
Tighten
1 2
N-8031MS's/8033MS's PC board
Note: The connection method for the N-8000MI, N-8000RS, N-8010RS, N-8400RS, N-8000DI and N-8000AF
is the same as for the N-8000EX.
Note
This terminal connection method also applies to
the N-8540DS.
Step 3. Tighten the terminal screws securely.
Notes
• Tug lightly on the cable to be sure that it does not pull free. If the cable pulls free, loosen the terminal
screw again and reconnect from Step 2.
• Use the screwdriver appropriate to the screws tightened into the terminal plug.
Step 4. (Removable terminal plug only)
Insert the wired terminal plug into the terminal block or the pin header.
Removable terminal plug
(supplied with the N-8000EX)
Removable terminal block
3
2
4
N-8000EX rear panel
Tighten
[N-8000ex]
Step 2. Loosen the terminal screws and insert the cables.