Toa N-8000 Series - Manual (Page 454)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
Multi Interface: Function Settings
5-44
(3) Aux input paging
Allows external input broadcasts to take precedence over all-zone paging and individual zone paging.
(4) Delay Time
Set the delay time before paging is initiated.
(5) paging response mode
Select either "Zone Selection" or "Automatic response" modes when responding to the paging.
Zone Selection: Responds to a paging call by designating the number of the paging zone. Respond
to the paging party who made the paging to the designated zone last is called. Use
this mode if paging announcements are heard from multiple zones.
Automatic response: Use only the paging response key to make a response. The responding station
is connected to the station that made a paging call over the paging zone through
which the responding station last received a call.
(6) priority settings
Sets whether paging calls or conversations should take precedence when these occur simultaneously.
Paging priority: When a call is received while receiving a paging call, the called station becomes busy
and the paging call is gone through. Station keys cannot be used while receiving a
paging call.
Conversation priority: A paging call is not received when paged during a conversation or dialing operation.
Station keys can be dialed even while receiving a paging call.