Toa N-8000 Series User Manual
Page 114
2-3
Chapter 2
FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
1.2. Receiving a Call
(when the system is set to "Sequential Response" mode)
Step 1. Answer a received call.
1-1. When the called station's incoming call mode is set to
"Automatic Connection Mode*," the call tone sounds
only once, after which the calling party's voice is heard
immediately through the internal speaker. Answer
by speaking into the station microphone or lifting the
handset.
1-2. When the called station's incoming call mode is set to
"Continuous call tone mode*," press any key for hands-free
conversation or lift the handset for handset conversation.
Tip
If a headset is connected to the called station, the call
tone is also heard from the station speaker.
Handset conversation is established when the handset is
lifted.
Step 2. To finish conversations, press the Clear key or replace
the handset.
* Use the supplied N-8000 Setting Software to perform Automatic
connection mode/Continuous call tone mode setting. (Refer to
,
.)
or
5
or
C
[Example]
Master station
1.3. Receiving a Call
(when the system is set to "Selective Response" mode)
Note: Only continuous call tones is available in "Selective Response" mode.
[Answering a call at the Standard Master Station]
Step 1. Answer a received call.
1-1. When responding by lifting the handset:
Lifting the handset stops the call tone and permits conversation to proceed.
1-2. Response with the Push-to-talk key
Pressing the Push-to-talk key enables hands-free conversation.
Step 2. To finish conversations, press the Clear key or replace
the handset.
or
PTT
or
C