Toa N-8000 Series - Manual (Page 250)

2-139
Chapter 2 FUNCTIONS AND OPERATION
N-8000AL TELEPHONE INTERFACE CONNECTED TELEPHONE
2.3.2. Absence transfer
When no response is made to a call to the telephone set for Absence transfer for a set period of time, the call
is automatically transferred to another designated station or telephone.
Calls received during conversations can be transferred. (Refer to p. 2-15 .)
The station to which a Absence transfer is to be transferred can be set either by a dialing operation (see below)
or using the supplied N-8000 Setting Software. (Refer to p. 5-99 .)
Use the supplied N-8000 Setting Software to enable or disable the Absence transfer or to set a calling duration.
(Refer to p. 5-97 .)
The station to which a call is to be transferred cannot be designated unless Absence transfer function is
enabled.
No. 62
No. 11 6 2
Call
A call is automatically
transferred to another
designated station after
a set period of time
Call tone
Call tone
The designated transfer
destination station
No. 63
Notes
Calls are not transferred under the following conditions,
• The designated station is set for Call forwarding.
• The designated station is not in standby mode
• The station set for Absence transfer is called as a representative or its associated member station of the
group.
Programming or erasure can be performed at your telephone.
[Programming] + + + 4 4 X X (Confirmation tone)
Function designation
number
Transfer destination
station number
[Erasure]
+ + + 4 4 Y Y (Confirmation tone)
The originally called
(your) telephone number
Function designation
number
Notes
• The telephone to which a call is to be transferred via multi interface unit or C/O line interface unit
cannot be programmed as a transfer destination station.
• The programmed contents set by dialing operation are automatically saved into the C/O line interface
unit at midnight every day. If the C/O line interface unit is turned off before completion of save, the state
returns to the contents that were programmed before power-off.