Toa N-8000 Series - Manual (Page 173)

2-62
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
5.5.6. Outside line Absence transfer
Outside line telephones can be designated as the transfer destinations for Absence transfer (refer to p. 2-19 ).
This Outside line Absence transfer function also applies to the call transfer ( p. 2-15 ) performed during
conversation.
• The station to which an Absence transfer is to be transferred can be set either by using the supplied N-8000
Setting Software or by station key operation. (Refer to p. 5-65 , 5-80 .)
• Use the supplied N-8000 Setting Software to enable or disable the Outside line Absence transfer function or
to set the transfer start/end time. (Refer to p. 5-35 , 5-62 .)
The station to which a call is to be transferred cannot be designated unless the Absence transfer function is
enabled.
• Settings must allow outside line calling operation.
Use the supplied N-8000 Setting Software to set the outside line access number and enable or disable
outside line calling operation. (Refer to p. 5-90 .)
• Even if the outside line telephone to which a call is made is busy, the call is automatically made to the free
outside line telephone for which the same access number is set. Thereafter, the telephone connected last
becomes the transfer destination telephone.
Call
A call is automatically
transferred to another
designated station after
a set period of time
Call tone
No. 62
No. 11 6 2
Call tone
Designated transfer destination telephone
Note
Calls received from an outside line telephone are not transferred to the destination station, but only the Master
Station to transfer is called.