Toa N-8000 Series - Manual (Page 298)

2-187
Chapter 2 FUNCTIONS AND OPERATION
OTHER FUNCTIONS (CONVENIENT FUNCTIONS)
13. REMOTE DIAL CONTROL
(only when the N-8000MI/8000DI is used)
When the N-8000MI/8000DI's contact input terminal is closed, an arbitrary station is made to automatically
perform dial operation. A set of up to 32 dial codes (including dial numbers and key operations) can be assigned
to each contact input terminal.
For example, signals from a sensor can automatically activate a station to make a call as shown below.
Use the supplied N-8000 Setting Software to perform settings for the Remote dial control. (Refer to p. 5-48 ,
5-116 .)
Note
To perform the remote dial control, the contact input terminal needs to be closed for over 50 ms.
[Example]
No. 200 station automatically calls the No.100 station by means of a make contact input to the N-8000MI/8000DI
from a sensor.
No. 100 No. 200
Calls No. 100.
Remote control activation
N-8000MI/8000DI
Sensor, etc.
Make contact
1 0 0
Call tone