Toa N-8000 Series User Manual
Page 47
1-30
Chapter 1
GENERAL DESCRIPTION
6.1.9. N-8033MS Flush-Mount Master Station
2
1
11
3
4
5
9
10
6
7
8
12
1 2
7
8
9
C
COM
14
13
1. Status indicator (red)
Flashes when a call is received, continuously lights
during a conversation, and is off while in standby
mode. The indicator also continuously lights while
receiving a paging announcement.
2. Paging key [CALL]
Makes a paging. (Refer to
.)
3. Hold key [HOLD]
Places the conversation on hold. (Refer to
4. Push-to-talk key [PTT]
Pressing this key while calling a party by means
of a continuous call tone permits a voice call to be
made. (Refer to
.) Also, pressing this key
during a hands-free conversation establishes a
one-way conversation from the party who pressed
the key. (Refer to
.)
5. Speaker
Outputs call tones and used for hands-free
conversations.
6. Paging response key. [RESP.]
Responds to a paging. (Refer to
7. Function key [FUNC.]
Use this key to perform function settings such as
assigning call transfer recipients or programming
one-touch dialing.
8. Redial key [RE.]
Permits the last called number to be dialed. (Refer
to
.)
9. Transfer key [XFER.]
Used to transfer the current conversation to
another station. (Refer to
10. Dial keys
Use these keys to make a call or set a function.
11. Clear key [C]
Terminates the conversation.
12. microphone
Used for hands-free conversation.
13. Line connection terminals [1, 2]
Connect to the exchange. (Pin header)
Note
The removable terminal plug (2P) is factory-
attached. (Refer to
.)
14. External dial input terminals [CN306]
An external switch such as a footswitch can be
connected. (Refer to
.)
One-touch dial function needs be programmed
when using the external switch. (Refer to
.)
Note
The front protective sheet is a wear-and-tear item. It is highly recommended to replace it every 100,000 times
of operations (approx. 3 years) for any key.
Part code: 115-51-304-00
For replacement, please contact your nearest TOA dealer.
[Rear]
[Front]