Toa N-8000 Series - Manual (Page 401)

4-13
Chapter 4 SYSTEM DESIGN FLOW
Side TAB Item Default
Reference
page
Function settings 2 Access to emergency all paging call
operation
OFF
p. 5-67
Access to audio trigger setting
operation
OFF
External equipment control OFF
Speed dialing Onetouch dial * 1
-
SW: p. 5-68
ST: p. 2-12
Master calling
-
p. 5-68
Auto Dial * 2 -
ST: p. 2-11
Scan monitor Scan monitor sequencing time 3 seconds
p. 5-69
Monitor Alert None
Scan monitor group
-
Message Paging Operate message paging OFF
p. 5-70
Time-based message paging ON/OFF OFF
Time-based message paging Start time
-
Time-based message paging End time
-
Activation method Dial operation only
Paging zone number All
Repeat Repeated during
activation
Operation terminal to mute OFF
Access to internal contact output OFF
p. 5-71
Message paging direction Send ON
Message paging direction Receive OFF
Sync control mode Busy
Contact output MI/DI/AF equipment No.
-
Contact output Contact output No.
-
Sync control mode Make during
activation
Remote Mic Settings Talk key (PTT/LOCK selectable) PTT
p. 5-72
Talk key: Timeout (only when LOCK is
selected)
None
Chime: Start None
Chime: End None
Chime: Volume −6 (dB)
Chime: Delay Time 0 (second)
Setting Priority SX-2000
Number of RM-210 0
Function key
-
Pattern Zone
-
p. 5-77 Control Input/Output
-
One-touch Dial
-
• All of the above items except "Auto Dial" can be set on the N-8000 Setting Software.
* 1 Settings possible from the IP master station as well.
* 2 Settings possible only from the N-8500MS/8600MS IP Multifunctional master station.