P. 2-20 – Toa N-8000 Series User Manual
Page 131
2-20
Chapter 2
FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
No. 61
No. 62
(The originally called
station, which has been
set to the Call forwarding mode)
No. 63
(The designated transfer destination station)
6
2
Call tone
2.6.3. Call forwarding
Calls to stations set for call forwarding are automatically transferred to another designated station without
sounding a call tone.
Two different modes are available: one is Call forwarding, in which calls are manually rerouted to the selected
station, and the other is Time-based Call forwarding, which transfers calls only when the preset time is reached.
This Call forwarding function also applies to the call transfer (
) performed during conversations.
The station to which a Call forwarding is to be transferred can be set either by dialing operation (see below and
) or using the supplied N-8000 Setting Software. (Refer to
Use the supplied N-8000 Setting Software to enable or disable the Call forwarding function or to set the transfer
start/end time. (Refer to
.)
The station to which a call is to be transferred cannot be designated unless the Call forwarding function is
enabled.
Notes
Calls are not transferred under the following conditions.
• The station set for Call forwarding is called as an associated member station of the group.
• The designated station is the Remote microphone station placed in Privacy mode.
[Calls to stations manually set for Call forwarding]
Calls to the station manually set for Call
forwarding are automatically transferred to
the designated station without sounding a
call tone.
Programming can be performed at your station or the transfer destination station, while erasure at your
station.
[Programming at your station]
4
1
X
X
+
+
+
(Confirmation tone)
Function designation
number
Transfer destination
station number
[Erasure]
(available only at your station)
4
1
Y
Y
+
+
+
(Confirmation tone)
The originally called (your) station number
[Programming at the transfer
destination station]
4
2
Y
Y
+
+
+
(Confirmation tone)
The originally called (your) station number
Notes
• The station to which a call is to be transferred via multi interface unit cannot be programmed as a
transfer destination station.
• The programmed contents set by dialing operation are automatically saved into the exchange or IP
stations at midnight every day. If the exchange or IP station is turned off before completion of save, the
state returns to the contents that were programmed before power-off.