Toa N-8000 Series - Manual (Page 87)

1-70
Chapter 1 GENERAL DESCRIPTION
7.1.2. Remote microphone station’s functions
Function Description
Reference page
Operation Setting
Conversation Individual call
The desired party can be called by pressing the station
call key into which the station number to be called is
programmed.
p. 2-95 p. 5-76
Incoming
call
selection
Automatic
connection
Incoming calls are automatically connected after a brief
call tone (1 second) or without a call tone.
p. 2-96 p. 5-65
Continuous call
Calls continue with a continuous call tone (or without a
call tone) and a status indicator continuously flashes as
long as no response is made.
Speed
dialing
One-touch
dialing
Programming the dial operation (up to 32-digit numbers)
into a station key allows paging or other operation to be
performed by one-touch dialing.
p. 2-100 p. 5-68
Dial pattern
activation
When the dial operation (up to 380-digit numbers) is
preprogrammed into the Remote microphone station as
a dial pattern, such programmed paging can be made.
p. 2-100 p. 5-78
Privacy
The Privacy function refuses station calls and all paging
except Emergency paging calls.
p. 2-101 p. 5-75
Paging
Selectable
paging
Calls can be made to up to 50 zones of the
preprogrammed multiple zones (N-8000 paging zones
and paging zone patterns).
p. 2-102 p. 5-67
p. 5-121
Paging
response
Automatic
response
Dialing the Paging Response key automatically initiates
a response to the paging last received.
p. 2-105 p. 5-63
Zone number
designation
paging
Dialing the number assigned to paging response
automatically initiates a response to the last zone-
designated paging.
Broadcast
to SX-2000
system
(only when
SX-200IP is
used)
Selected zone
broadcast
Broadcasts can be made to the SX-2000 system zones.
p. 2-106
p. 5-28
p. 5-72
p. 5-77
General-purpose
broadcast
The General broadcast pattern having been set in the
SX-2000 system can be activated.
p. 2-110
BGM broadcast
The BGM pattern having been set in the SX-2000
system can be activated.
p. 2-111
Control output
activation
The control output of the SX-2000 system can be
activated.
p. 2-111
Multi-operation
activation
Multiple operations including the SX-2000 selected zone
broadcast, SX-2000 system’s control output pattern
activation, and N-8000 paging can be performed at the
same time.
p. 2-112
p. 5-28
p. 5-72
p. 5-77
p. 5-121
Hold
Mic off
When it is desirable to hold the line during a conversation,
if any dialing key ([0] – [9]) is pressed, the microphone
is disabled as long as the key is pressed.
p. 2-14
Call hold
Pressing the Hold key during a conversation places the
conversation on hold, transmitting a hold tone to both
parties. If the Hold key is pressed again, the hold mode
is cancelled, and the original conversation is restored.
p. 2-14