Toa N-8000 Series - Manual (Page 597)

7-8
Chapter 7 MULTIFUNCTIONAL STATION MENU SCREEN OPERATION (N-8000MS/8500MS/8600MS only)
1 : N e t w o r k s e t
2 : L i n e A t t r i b u t e
I P A d d r e s s
1 9 2 . 1 6 8 . 0 0 1 . 1 2 8
S u b n e t m a s k
2 5 5 . 2 5 5 . 2 5 5 . 0 0 0
S u b n e t m a s k
2 5 5 . 2 5 5 . 0 0 0 . 0 0 0
D e f a u l t g a t e w a y
1 9 2 . 1 6 8 . 0 0 1 . 2 5 4
D a f a u l t g a t e w a y
1 9 2 . 1 6 8 . 2 5 4 . 0 0 1
I P A d d r e s s
1 9 2 . 1 6 8 . 0 0 5 . 0 6 4
1 : N e t w o r k s e t
2 : L i n e A t t r i b u t e
1 0 : 0 8 A M
2 0 0 0
X
X
X
7.2. Network Settings
It is possible to change the IP address, subnet mask, and default gateway of the exchange or N-8500MS/8600MS*.
* Exchange when the station performing setting is N-8000MS, and the N-8500MS/8600MS itself when it is the
N-8500MS/8600MS.
Step 1. Using the up or down arrow keys or the [1] key on the
maintenance screen, move the cursor to "1: Network
set."
Step 2. Press the Select key to display the IP address of the
exchange to which the station is connected or of the
N-8500MS/8600MS.
Step 3. Using the dial keys, enter the desired IP address,
then press the Select key. When not changing the IP
address, press the Select key only.
The subnet mask of the exchange or
N-8500MS/8600MS is displayed.
• The periods (.) within the IP address need not be
entered. Enter numerals consecutively.
• If a number separated by a period is a single or
double digit number, add the prefix [0] or [00] to
make them 3-digit numbers. For example, enter the
IP address "192.168.5.64" as "192168005064."
Step 4. Using the dial keys, enter the desired subnet mask,
then press the Select key. When not changing the
subnet mask, press the Select key only.
The default gateway of the exchange or N-8500MS
/8600MS is displayed.
Note
For entering figures, follow the same process as Step
3.
Step 5. Using the dial keys, enter the desired default gateway,
then press the Select key. When not changing the
default gateway, press the Select key only.
The screen reverts to the system setting item selection
display, completing the change in network settings.
Note
For entering figures, follow the same process as Step
3.
Step 6. Press the Menu key to return the display to its normal
standby mode.
Note
Network settings are not immediately updated, but must be made effective by restarting the exchange or
N-8500MS/8600MS.
To restart the exchange, press the Reset key located on the front panel of the exchange or use the exchange
reset screen (refer to p. 7-11 ).
To restart the N-8500MS/8600MS, use the exchange reset screen (refer to p. 7-11 ).