Toa N-8000 Series - Manual (Page 431)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
General: Equipment Registration
5-21
Step 3. Set the Equipment name, Model, IP Address, and Web Port.
These items can be set directly by clicking and editing the data in each cell, or by importing equipment
data detected using the Unit Scan/Network Setting function. Follow the below procedures when
importing data from the result of Unit Scan.
3-1. Press [Import from scan result] to display the following dialog.
3-2. Select an import destination from [Equipment Registration], and select an import source from [Equipment
Table], then press the [import] button. This will cause the settings data for the detected equipment to be
copied to the equipment selected as the import destination.
Note
Be sure to match the model number of import source with that of import destination for selection.
3-3. Click [OK] to close the dialog and return the display to the previous edit screen.
Step 4. Change the WAN IP address and the WAN Web port as required by clicking and editing the contents
of each cell directly.