Toa N-8000 Series - Manual (Page 425)

Chapter 5 SYSTEM SETTINGS BY SOFTWARE
5-15
4. UNIT SCAN (NETWORk SETTINGS)
These functions enable the detection and network setting of Exchanges, various kinds of interface units, and
IP stations connected to the local area network.
The equipment detection function can only be used within the effective broadcast range (refer to p. 8-9 ).
Other equipment must be set using a different network setting (refer to p. 4-3 ).
4.1. Screen Description
Click [Unit Scan (Network Settings)] on the initial screen.
The Equipment Detection screen starts up, initiating automatic equipment detection.
The following shows an example of the screen displayed after equipment has been scanned, including a list of
scanned Exchanges, various kinds of interface units, and IP stations.
(1) Communicable Equipment
Displays all devices that can perform communications
normally.
(2) Non-Communicable Equipment
Displays all devices that cannot correctly
communicate network settings.
(3) Status Reacquisition button
Re-enables equipment detection.
(4) Delete button
Deletes selected device from the list.
(5) Change Ip Settings button
Changes IP settings of selected device.
(6) Transmit Setting Change Information button
Transmits changed settings to device.
(7) End button
Terminates equipment detection.