P. 5-27, P. 5-27, 5 – Toa N-8000 Series User Manual
Page 437
Chapter 5
SYSTEM SETTINGS BY SOFTWARE
General: System Settings
5-27
Sun Mon Tue Wed Thu
Fri
Sat
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
30
24
25
26
27
28
29
June
Sun Mon Tue Wed Thu
Fri
Sat
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
October
Start of DST
End of DST
(5) DST (Summer time) Settings
Set daylight saving time.
with DST: Set whether or not to enable daylight saving time.
Start/End: Set the date and time to start and end daylight saving time. Designate it in the format [hour] of
[day] of [nth week] of [month]. The last day of the week in the month can also be designated.
(Setting example)
(6) NTp Settings
NTP server address: Enter the IP address of the NTP server.
NTP server port:
Enter the port number of the NTP server.
NTP sync time:
Set time to communicate with the NTP server.
Note: NTP Ver. 3 is used to synchronize the system clock.
(7) Clock sync time
When the master clock has been designated, set the time at which system clocks are synchronized.
Notes
• It is recommended to set the Clock sync time later than the NTP sync time.
• Setting the Clock sync time and the NTP sync time to the same time may cause some system equipment
not to be adjusted to the correct time even after NTP synchronization.
(8) C/O control password
Set the C/O control password.
(9) System password button
Set the System password.
(10) Maintenance password button
Set the Maintenance password.
When set as above, the DST will start
and end as shown on the calendar at
right.