Toa N-8000 Series - Manual (Page 156)

2-45
Chapter 2 FUNCTIONS AND OPERATION
MASTER STATION'S FUNCTIONS AND OPERATION
[Operation]
Step 1. Automatic Scan
1-1. When scan-monitoring the preprogrammed stations
Press the [ ], [2] keys, then the monitor group number (1 − 4), followed by the [ ] key.
When monitoring two or more groups, press the group numbers consecutively.
1-2. When scan-monitoring by designating the station numbers
Press the [ ], [2], [ ] keys, then the station number.
To select the station number consecutively, press the [ ] key.
To terminate the station selection, press the [ ] key following the station number.
• Scan monitoring starts and cycles through the station groups in preprogrammed sequence or in order
of being selected at specified time intervals until its operation is manually stopped.
• Both the number and name of the station being monitored are displayed on the monitoring station's
LCD. (N-8000MS/8500MS/8600MS only)
[Example] Station No. 331 is being monitored.
• A handset can also be used for monitoring.
Step 2. Manual Scan
2-1. Stopping and restarting automatic scan
To continuously monitor a specified station, press the [0] key when that station is displayed to stop
automatic scan operation. Pressing the [0] key again restores automatic scan operation.
2-2. Advancing a scan
Pressing the [ ] key advances the scan by one station.
2-3. Moving back a scan
Pressing the [ ] key moves the scan back one station.
2-4. Warning the monitored station by voice
To transmit a voice warning to the monitored station, press the Push-to-talk key.
Step 3. Scan Monitor end
To end Scan monitor, either press the Clear key or replace the handset.
3 3 1 : E l e v
i n g
a t o r
S c a n o n i t o r m
Station No. Station name