Toa N-8000 Series - Manual (Page 646)

8-46
Chapter 8 APPENDIX
5.41. N-8000DI Direct Select Unit
• Accessories
AC power cord (2 m) .............................................. 1
CD (for PC setting, maintenance use) ................... 1
Removable terminal plug (10 pins) ........................ 4
Removable terminal plug (16 pins) ........................ 4
Plastic foot ............................................................. 4
Machine screw M3 x 8 ........................................... 4
Rack mounting bracket .......................................... 2
Tapping screw 3 x 8 .............................................. 8
Rack mounting screw with plain washer ............... 4
Note: The design and specifications are subject to change without notice for improvement.
Wall mounting bracket: YC-850
• Optional product
Power Source CE version: 220 – 240 V AC, 50/60 Hz
CU version: 120 V AC, 50/60 Hz
Power Consumption 16 W (max.)
Contact Input 32 inputs, no-voltage make contact input, open voltage: 24 V DC,
short-circuit current: 5 mA or less, removable terminal block (20 pins)
(1 common terminal for 4 inputs)
Contact Output 32 outputs, relay contact output, contact capacity: 24 V DC/2 – 500 mA,
removable terminal block (32 pins)
Network Section Network I/F: 10BASE-T/100BASE-TX (Automatic-Negotiation)
Network protocol: TCP/IP, UDP, HTTP, RTP, ARP, ICMP, IGMP
Connector: RJ-45 connector
Indication LNK/ACT indicator, Status indicator, Power indicator,
Channel status indicator (32 channels)
Other Firmware update function, System data hold function, Time of day hold
facility, Reset key (front panel)
Setting Method Rack, Desk, Surface mounting
Operating Temperature 0 to 40°C
Operating Humidity Under 90 % RH (no condensation)
Finish Pre-coated steel plate, black, 30 % gloss
Dimensions 420 (w) x 44.3 (h) x 267 (d) mm
Weight 2.8 kg
Network Section Network I/F: 10BASE-T/100BASE-TX (Automatic-Negotiation)
Network protocol: TCP/IP, UDP, HTTP, RTP, ARP, ICMP, IGMP
Connector: RJ45 connector for LAN
Voice sampling frequency: 16 kHz, 8 kHz (controllable on the software)
48 kHz sample rate is used for SX-2000 system only.
Quantifying bit number: 16-bit
Voice encoding method: Sub-band ADPCM, Cryptosystem
Voice packet loss recovery: Silence insertion
Audio delay time: 80 ms, 320 ms (controllable on the software)
Indicator Operation indicator (RUN)
Operating Temperature 0 to 40 ºC
Operating Humidity 90% RH or less (no condensation)
Finish Panel: Pre-coated steel plate, black, 30% gloss
Dimensions 35 (w) x 119.5 (h) x 178.4 (d) mm
Weight 150 g
Note: The design and specifications are subject to change without notice for improvement.
5.42. SX-200IP IP Module